Epson PX-049A Error 0x0097
Epson PX-049A Error code 0x0097, also known as the STK LOAD POSITION excess load error, is a common issue that may occur on certain printer models. When encountering this error, users may notice a display message on their printer indicating the error code 0x0097.
This error usually arises due to various factors, including the presence of remaining protective material within the printer, a failure in the panel encoder, an overload in the pickup roller driving system, or a disconnection in the cable or FFC (Flexible Flat Cable) connection.
One possible cause of this error is the existence of protective material that was not removed during the initial setup or cartridge installation. In such cases, carefully check all areas of the printer for any remaining packaging materials and promptly remove them to resolve the issue.
Another likely reason could be a malfunctioning panel encoder, which is responsible for communicating the position of various printer components. To troubleshoot this, power off the printer and disconnect it from the power source. Reconnecting the printer after a few minutes can sometimes reset the encoder and resolve the error.
If the error persists, it could indicate an overload in the pickup roller driving system. This issue may require professional assistance for proper diagnosis and resolution.
Additionally, a cable or FFC disconnection can also trigger this error. In such instances, it is advised to make sure all cables and FFCs are securely connected. If any cable appears damaged or loose, it may need to be replaced or properly reconnected.
Overall, error code 0x0097 on the Epson PX-049A printer may result from remaining protective material, panel encoder failure, overload in the pickup roller driving system, or cable and FFC disconnection. By carefully troubleshooting these possible causes, users can effectively resolve this error and resume printing functionality.
| Printer Model | Epson PX-049A |
| Error Code | 0x0097 |
| Display on | PRINTER |
| Description and troubleshooting | STK LOAD POSITION excess load error. Remaining protective material. Panel Encoder failure. Pickup Roller driving system overload. Cable or FFC disconnection. |
