Epson ET-2550 Error 0xE8
The Epson ET-2550 printer may display the error code 0xE8, typically accompanied by a message stating “CR LOAD POSITION reverse error.” This error indicates that the CR motor, responsible for controlling the movement of the carriage, is not rotating in the correct direction during the printing process. There are several potential causes for this error, including CR encoder failure, paper jam, tooth skip or improper tension of the timing belt, or even a main board failure.
The CR encoder is an essential component that helps the printer accurately position the carriage during printing. If it fails, the printer may encounter difficulties in determining the correct position, leading to the error code 0xE8. Additionally, a paper jam might interfere with the movement of the carriage, causing it to reverse and triggering the error.
Another possible cause is an issue with the timing belt, such as a tooth skip or improper tension. The timing belt controls the synchronized movement of various printer components, including the CR motor. If the belt is not properly aligned or sufficiently tensioned, it can result in the reverse movement and subsequent error.
In some cases, the error may be indicative of a more severe problem, such as a failure of the main board. This component acts as the central control unit for the printer, so any malfunction can cause various errors to occur, including the CR LOAD POSITION reverse error.
To troubleshoot this error, it is recommended to first check for any paper jams and remove any obstructing pieces carefully. Additionally, inspect the timing belt for any visible damage or misalignment and adjust it accordingly. If these steps do not resolve the issue, contacting Epson customer support or a certified technician may be necessary to address potential encoder or main board failures.
| Printer Model | Epson ET-2550 |
| Error Code | 0xE8 |
| Display on | PRINTER |
| Description and troubleshooting | CR LOAD POSITION reverse error. The CR motor does not rotate to the normal direction during printing. CR encoder failure. Paper jam. Tooth skip or improper tension of the timing belt. Main board failure. |
