Epson PX-S5080 Error Code 0x02C7 Part 48201

Epson PX-S5080 Error 0x02C7

Epson PX-S5080 Error 0x02C7

If you are encountering an Epson PX-S5080 Error code 0x02C7 with the message “EJ2 load position excess load error” displayed on your printer, it is important to understand the description of this error and how to troubleshoot it.

The Error code 0x02C7 indicates that the EJ2 motor, which is responsible for the printer’s operation, has stopped running in the middle of a task. There are several potential reasons for this error, including obstacles such as jammed paper, overload of the paper feed mechanism, disengaging or breakage of the gears, failure to read the EJ2 motor encoder, jumping of the timing belt, contamination of the EJ2 encoder scale, failure of the EJ2 motor (not completely broken), or failure of the main board.

To troubleshoot this error, you can follow these steps:

1. Check for any jammed paper or other obstacles in the printer’s paper path. Clear any obstructions and ensure the paper is loaded correctly.

2. Check the paper feed mechanism for any signs of overload or damage. If necessary, clean or repair the mechanism.

3. Inspect the gears for any disengaging or breakage. Replace any damaged gears.

4. Ensure that the EJ2 motor encoder is clean and free from any dirt or debris. Clean the encoder scale if necessary.

5. Check the timing belt for any signs of jumping or misalignment. Adjust or replace the timing belt if needed.

6. If none of the above steps resolve the issue, it is possible that the EJ2 motor or the main board is faulty. In this case, it is recommended to contact Epson customer support for further assistance or to arrange for a repair.

By following these troubleshooting steps, you can hopefully resolve the Epson PX-S5080 Error code 0x02C7 and get your printer back up and running smoothly.

Printer Model Epson PX-S5080
Error Code 0x02C7
Display on PRINTER
Description and troubleshooting EJ2 load position excess load error. The EJ2 motor stopped running in the middle of the operation. The EJ2 was stopped by Obstacles such as jammed paper Overload of the paper feed mechanism Disengaging or breakage of the gears. Failed to read The EJ2 motor encoder. Jumping of the timing belt. Contamination of The EJ2 encoder scale. Failure of The EJ2 motor (not completely broken). Failure of the main board.

Add Comment